Hilti Nuron SC 6ML-22 Manual De Instrucciones Original página 16

The fence can be fitted on either side of the base plate.
4 Technical data
4.1 Product properties
Rated voltage
Weight
Saw blade diameter
Saw blade disc thickness
Kerf width
Saw blade arbor size
Rated speed under no load
Maximum cutting depth
Storage temperature
Ambient temperature for operation
4.2 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 8
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
10 English
SC 6ML-22
21.6 V
2.46 kg
(without battery)
160 mm ... 165 mm
1.2 mm
1.2 mm
16 mm
4,000 /min
60 mm
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
21.6 V
See the end of these operating
instructions
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
2360041
*2360041*