Husqvarna TC 238T Manual De Usuario página 14

3. Remove the bolt (A).
B
C
4. Put the full lever shroud (B) in the slots (C).
5. Push the lever (D) through the full lever shroud
and install the bolt (A).
D
6. If it is necessary to adjust the full lever, do the
steps that follow.
a) If the grass is heavy or wet, remove the bolt
and put the full lever in the fully retracted
position. Install the bolt again.
b) If the grass is light or dry, remove the bolt
and put the full lever in the fully extended
position. Install the bolt again.
To install the presence lever for the
grass catcher
1. Stop the engine and engage the parking brake.
2. Put the presence lever (A) into the slots in the
backplate.
3. Install the screw (B) and the nut (C).
14
A
A
B
C
A
To adjust the seat
1. Sit in the seat.
2. Lift up the seat adjustment lever (A).
3. Move the seat until it is in a position where you
can push the brake and clutch pedals down.
4. Release the seat adjustment lever (A) to lock the
seat in position.
To connect the battery
WARNING:
Make sure that ignition switch is in the
OFF position and that the ignition key is
removed.
The cable connections are on the plate on the right
side of the product, above the rear wheel.
1. Make sure that the red cable (A) is tightly
installed to the starter solenoid.
B
C
2. Make sure that the protective sleeve (B) does not
touch the terminal end (C) on the black cable (D).
A
Risk of electrical shock.
A
D
2010 - 003 - 10.04.2023