Publicidad
Idiomas disponibles
Idiomas disponibles
To engage and disengage the
cutting deck
WARNING:
cutting deck without a deflector or grass
catcher installed to the grass discharge.
The product has an operator presence control
(OPC). When you go away from the seat with the
engine on and the cutting deck engaged, the engine
stops.
Stay fully and in the center of the seat to make sure
that the engine operates correctly and does not stop
on rough terrain or hills.
1. Set the correct cutting height. Refer to
cutting height on page 17 .
2. Move the attachment clutch control.
a) Move the attachment clutch control forward to
engage the cutting deck.
b) Move the attachment clutch control rearward
to disengage the cutting deck.
To use the reverse operation system
(ROS)
Note:
If you try to go rearward with the product
when the cutting deck is engaged, the engine stops
immediately. Engage the ROS to go rearward with
the product when the cutting deck is engaged.
WARNING:
operate the product rearward, look down
and behind the product for the safety of
others.
2010 - 003 - 10.04.2023
Do not operate the
To set the
Before and while you
1. Turn the ignition key counterclockwise to the
ROS "ON" position (A) to engage the ROS.
A
2. Slowly push down the reverse drive pedal to start
movement.
3. Turn the ignition key clockwise to the engine
"ON" position (B) to disengage the ROS.
To get a good cutting result
•
For best performance, do maintenance on the
product regularly as given in the maintenance
Maintenance schedule on
schedule. Refer to
page 22 .
•
Do not cut a wet lawn. Wet grass can give a bad
cutting result.
•
Do not use tire chains when you attach the
cutting deck to the product.
•
Make sure that the cutting deck is level. Refer to
To adjust the parallelism of the cutting deck on
page 29 .
•
If the grass is high, start with a high cutting
height and decrease it gradually.
•
Move the product forward at low speed if the
grass is high and thick.
•
Use full throttle when you cut the grass.
•
Cut the grass in an irregular pattern.
•
Use the left side of the cutting deck when you
cut near trees, bushes or paths. The blade cuts
approximately 15 mm in from the side of the
cutting deck.
•
When you cut large areas, move the product
to the right during 1 or 2 turns around
the work area. This procedure will keep the
grass discharge away from shrubs, fences and
driveways. After approximately 2 turns around
the work area, cut in the opposite direction.
•
To get the best cutting result, cut the grass
frequently.
B
19
Publicidad
