Rewa Mirabello MIR 30 Instrucciones Y Garantía página 30

To change the brightness of each phase, simply press the
Therefore:
• During the daytime phase, press the
At the first continuous press, the brightness will be reduced gradually from 100% to 15% (minimum limit for the daytime phase).
• It is possible to block the brightness setting at any time by releasing the
The selection will be saved automatically and maintained over time until new programming or in the event of a power failure
lasting Mirabello than 40 minutes.
• It is possible to change the saved setting by pressing the
WARNING: Starting from the basic settings, press the
EN
increase it.
• When the minimum set level (15%) or the maximum set level (100%) has been reached, the the red LED in the centre of the
touch screen will flash.
Do the same to change the brightness of the night-time phase (max 15% - min 0%).
Manual power on/off of the LED strip:
If necessary, it is possible to turn the lights of the LED strip on or off using the
programmed.
In particular, the key
• Turns on the LED lights at their maximum power if they are off, or at any previously programmed brightness during the
night-time phase;
• Turns off the LED lights if turned on manually, or at any previously programmed brightness during the daytime phase;
• Turns on the lights at their maximum brightness or turns them off during the sunrise or sunset phases
WARNING: if the manual activation key
customised), the lights will remain on or off until the next phase of the program starts, restoring the current
program.
For example, if the lights are turned on during the night-time phase and they are not turned off manually, they
will remain on until the sunrise phase starts. The program will then follow its usual course.
Cancelling manual power on/off and restoring the program:
To cancel the manual power on/off command and restore the preset or customised program of the LED strip, simply press the
key.
The aquarium lighting system will resume the program considering the time that elapsed in manual power on/off mode.
V.m FILTERING ENHANCEMENT (MIR 70 aquarium) ADDITION OF A SECOND MIRA-FILTER:
In case it is necessary to strengthen the system of filtering, please do the following:
1) Buy a NEWA Mirafilter MF100 in stores specializing in the sale of aquariums.
2) Attach only 2 suckers to the back of the filter and determine the location of the filter in the aquarium.
3) Mount the optional filter on specific support hooks and press down the lower part to fix 2 suckers.
3) Hook the additional filter to the specific support hooks provided on the inner frame of the aquarium and press in the lower
part to attach the 2 suction cups.
4) While holding the aquarium lid open firmly with one hand, remove the cable passage protection cover by pulling it toward
yourself (fig. 8).
5) Extract the plug and power cable of the second filter from the specific opening provided on the lid.
key to change the basic settings (brightness 100%).
:
is pressed during any of the programming phases (preset or
key during the specific phase.
key.
key again.
key once to reduce the brightness; press it again to
key, which always has priority over what is
30