Publicidad
7
Troubleshooting
Check this list before contacting the
service. Doing so will save you time
and money. This list includes frequent
complaints that are not related to
faulty workmanship or materials.
Certain features mentioned herein
may not apply to your product.
The refrigerator is not working.
• The power plug is not fully settled.
>>> Plug it in to settle completely
into the socket.
• The fuse connected to the socket
powering the product or the main
fuse is blown. >>> Check the fuses.
Condensation on the side wall of
the cooler compartment (MULTI
ZONE, COOL, CONTROL and FLEXI
ZONE).
• The door is opened too frequently
>>> Take care not to open the
product's door too frequently.
• The environment is too humid. >>>
Do not install the product in humid
environments.
• Foods containing liquids are kept
in unsealed holders. >>> Keep the
foods containing liquids in sealed
holders.
• The product's door is left open. >>>
Do not keep the product's door open
for long periods.
• The thermostat is set to too
low temperature. >>> Set
the thermostat to appropriate
temperature.
Compressor is not working.
• In case of sudden power failure
or pulling the power plug off and
putting back on, the gas pressure
in the product's cooling system is
not balanced, which triggers the
compressor thermic safeguard.
The product will restart after
approximately 6 minutes. If the
product does not restart after this
period, contact the service.
• Defrosting is active. >>> This
is normal for a fully-automatic
defrosting product. The defrosting is
carried out periodically.
• The product is not plugged in. >>>
Make sure the power cord is plugged
in.
• The temperature setting is incorrect.
>>> Select the appropriate
temperature setting.
• The power is out. >>> The product
will continue to operate normally
once the power is restored.
The refrigerator's operating noise
is increasing while in use.
• The product's operating
performance may vary depending on
the ambient temperature variations.
This is normal and not a malfunction.
The refrigerator runs too often or
for too long.
• The new product may be larger than
the previous one. Larger products
will run for longer periods.
• The room temperature may be
high. >>> The product will normally
run for long periods in higher room
temperature.
26
EN
Publicidad
