ICY BOX IB-564SSK Manual página 4

1. Features
• 4x 3.5" SATA or SAS HDD/SSD in 3x 5,25" bay
• Trayless and easy installation
• Aluminum and Stainless Steel
• Intelligent Fan Control (6x6cm fan)
• Audio + LED Alarm for fan failure and overheating
• Individual Power-Switch
• Hard disk capacity not limited
• SATA I/II/III host interface 6.0 Gbit/s
• With key lock to secure the HDDs
• LED for power, HDD access
• Patented NSS SATA/SAS connector supports 50.000 times Hot Swap
2. Packing Content
IB-564SSK-B, 4x SATA cables, 2x Keys, 8x Screws, 1x Manual
3. Front & Rear Panel
1 2 3
1. Power Button with LED for power and Access (blue) 1. Power Ports
2. Key Lock
3. Door Handle
4. Installation
1. Remove the cover of an empty drive bay of 3x 5.25" space. Smoothly insert the IB-564SSK into the bay
and push it inwards until its screw hole is aligned with the hole of the bay. Use two screws on each side
to securely hold the device. The installation-direction must beright: Lock at the left side!
2. Connect the SATA 15Pin power cable or Molex 4 Pin to the power supply of your PC. Connect the SATA
7Pin data cable to the connector on the rear side of the IB-564SSK, another end to the SATA 7Pin data
port on the main board (or SATA RAID card) of your PC.
IB-564SSK
1 2 3 4 5
2. Alarm Buzzer
3. Temperature Alarm Setting
4. Fan Setting Mode
5. LED indicator switch OFF / ON
6. SATA DATA Connector (7pin)
4
6