Beta 1498-25A Manual De Uso E Instrucciones página 13

EN
OPERATION MANUAL AND INSTRUCTIONS
• RECOVERY FUNCTION (RECON): This charging mode is used to recover 12V Wet batteries that have been left unused for
a long time and in which the acid has stratified. This function physically acts on the electrolyte solution of the battery, so that it
mixes again and contrasts stratification.
• SHOW ROOM FUNCTION: The battery chargers are provided with the Show room function, which is used to keep all the
equipment of the vehicle running during demos in the car shop. (Only in 12V mode)
• SUPPLY FUNCTION: The battery chargers are provided with the Supply function (power supply). This function is used to keep
a vehicle's memory banks active while the battery is being changed or whenever the battery is disconnected from the vehicle's
circuit. (Only in 12V mode)
• BATTERY TESTS AND ERROR INDICATORS: The battery chargers are designed to determine the battery's condition before
and while charging, and inform about any connection faults between the battery charger and the battery to charge. An error code
can be viewed on the digital display, which allows the fault to be quickly and simply checked out.
CHARGING
Charging batteries connected to vehicle
1. Before starting to charge the battery, make sure that the power supply lead is not plugged into the mains.
2. Locate the vehicle's earthing point, which is normally connected to the negative battery terminal.
3. Charging a battery with negative terminal grounded to the vehicle's chassis.
• Connect the red clamp to the positive terminal (+) of the battery.
• Connect the black clamp to the vehicle's earthing point, keeping it away from the battery and the fuel pipe.
4. Charging a battery with positive terminal grounded to the vehicle's chassis.
• Connect the black clamp to the negative terminal (-) of the battery.
• Connect the red clamp to the vehicle's earthing point, keeping it away from the battery and the fuel pipe.
Charging batteries that are not connected to a vehicle
1. Before starting to charge the battery, check that the power supply lead is not plugged into the mains.
2. Connect the red clamp to the positive terminal (+) of the battery.
3. Connect the black clamp to the negative terminal (-) of the battery.
CAUTION Make sure that both clamps of the output leads generate a suitable contact with their respective terminals.
HOW TO USE BATTERY CHARGER
1. Connect the output leads to the battery.
2. Plug the power supply lead of the battery charger into the mains, making sure the voltage matches the rated voltage of the
battery charger (230V-50Hz);
3. With the battery charger in "stand-by" mode and the ON LED lighting up, set the charging parameters suitable for the type of
battery to charge using the keys on the control panel.
The "Mode" key can be used to set the following modes: 12V, SHOW ROOM, SUPPLY and 24V
13