Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Bucket Full – When the water bucket is full, the unit will automatically shut off, make a
beeping noise and the bucket full indicator will light up. The dehumidifier will not function
until the water bucket is emptied and placed back in the unit.
8.
Child Lock Mode – To lock the control panel, press and hold the Timer button for 3 seconds
when the unit is ON. When locked, the lock indicator will light up. Press and hold the Timer
button for 3 seconds to unlock the control panel.
9.
Pre-Set Mode – Press the Mode button to choose from the preset options of Bedroom (55%
RH), Basement (45% RH), or Continuous Mode.
10.
Clean Filter - The Clean Filter LED will light up after 250 hours of use as a reminder to clean
the filter. Remove the filter from the back of the unit by using your thumbs to press down on
the filter tabs directly above the filter. Clean the filter with warm, soapy water. Dry thoroughly
before replacing the filter. Once the filter is completely dry, place the filter back in the unit
and press the Filter button to reset the filter indicators.
For Model(s) with PUMP
Internal Pump Mode – The internal pump allows the unit to operate without having to empty the
bucket and requires the installation of the included pump drain hose kit (do not use a garden
hose). While the unit is Off, to install the hose, remove the drain cap on the back of the unit. The
pump mode operation will pump water up to 16 feet lengthwise using the hose included. Force the
hose on to the pump adapter and turn the adapter clockwise on to the threaded connection on
the back of the unit. Once securely installed, lead the drain hose to a nearby drain, sink, or out of a
window. Turn on the dehumidifier and press the Pump button to activate the internal pump. The
"Pump" LED indicator should illuminate.
Note:
the pump will not engage until the water tank is almost full.
For Model(s) with UVC
Press and hold the mode for 3 second until the UV indicator turns on. To turn the UV function off,
press and hold the mode button for another 3 seconds until the indicator turns off. Should any UV
light be exposed, stop use immediately and contact customer service.
12
Publicidad
