Asko HDB1153T Instrucciones De Uso página 7

ADJUSTING AND FIXING THE IRONING BOARD (BEFORE FIRST USE)
CLICK
Press on the hidden helper door to open it.
1
Hold the ironing board handle and pull it out towards you as
far as it will go.
Unfold (open) the ironing board in the direction indicated
2
in the fi gure.
Check for stability before using for the fi rst time. When
3
the ironing board is in the locked position, it is very
important that its back part is pressed tightly against the
dryer.
If the ironing board does not fi t tightly, it can be adjusted as
necessary. To do this, fold (close) the ironing board and follow
steps 4, 5 and 6.
Use a screwdriver to carefully undo the screws on the
4
guides on both sides (as shown in the fi gure) and pull out
the ironing board under a right angle (perpendicularly).
Detach the ironing board from the guides in the
5
perpendicular direction, and set the length of the plastic
plug extension on both sides.
Then, replace and tighten the screws removed in step 4.
6
Replace the ironing board (under a right angle).
When replacing the board (under a right angle), it has to
7
audibly "CLICK" into place. Then, push the ironing board
towards the inside of the hidden helper.
Close the hidden helper door.
We reserve the right to modifi cations. 7