Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
7
Insert batteries.
Safety Warning
When installing batteries in the siren it will emit a loud tone
("beep beep") as you apply power. Since the tone may startle
you make sure that you cannot overbalance and fall, or drop
the siren.
At the Control Unit
1. Press "Back" repeatedly until you return to the top level
of installer mode.
2. Scroll down and select "Siren".
Press "On/Off" to operate the external and internal
sirens. Make sure that you can hear the external siren.
3. Press "Back".
4. Scroll down and select "Testing".
5. Scroll down and select "Ext Siren Signals".
The display shows the signal strength from the external
siren.
Make sure that the strength of the signal received from
the position you have chosen for the siren is above 3.
6. Press "Back".
7. Leave installer mode.
The system is now ready for use. By default the control unit
assigns the external siren to all partitions. See the 7500r
Installation and Programmng Guide if you wish to change this
assignment.
Page 10
8
Refit transparent battery
cover and trim cover.
497291
750r
Publicidad
