Black and Decker BDN200 Manual De Instrucciones página 10

492848-00,BDN200 NAILER
CLEAN AND INSPECT DAILY
Disconnect tool from air supply before cleaning and inspection. Correct
all problems before placing the tool back in use.
Wipe tool clean and inspect for wear or damage. Use non-flammable cleaning solutions
to wipe exterior of tool only if necessary. DO NOT SOAK tool with cleaning solutions.
Such solutions can damage internal parts.
Inspect trigger and safety mechanism to assure system is complete and functional: no
loose or missing parts, no binding or sticking parts.
Keep all screws tight. Loose screws can cause personal injury or damage tool.
If tool is used without an in-line oiler: place five or six drops of air tool oil into the tool's
air inlet on a daily basis.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service organizations, always using identical
replacement parts.
Disconnect tool from air supply before performing any Service
Procedure.
SYMPTOM
1. Air leak near top of
tool or in trigger area. Worn or damaged
2. Tool does nothing or
operates sluggishly.
3. Air leak near bottom
of tool.
4. Tool jams frequently.
5. Other.
ACCESSORIES
Recommended accessories for use with your tool are available from your local retailer
The use of any accessory not recommended for use with this tool could
be hazardous.
2/2/06 1:35 PM Page 10
MAINTENANCE
TROUBLESHOOTING
PROBLEMS SOLUTIONS
Loose screws. Tighten screws.
B&D service for overhaul.
o-rings or seals.
Inadequate air supply. Verify adequate air supply.
Inadequate lubrication. Put 5 or 6 drops of oil into air inlet.
Worn or damaged B&D service for overhaul.
o-rings or seals.
Loose screws. Tighten screws.
Worn or damaged B&D service for overhaul.
o-rings or bumper.
Incorrect fasteners. Verify approved fasteners of
correct size.
Damaged fasteners. Replace w/undamaged fasteners.
Magazine or nose Tighten screws.
screws loose.
Magazine is dirty. Clean magazine.
Driver is worn or damaged. B&D service for driver maintenance.
Contact a Black & Decker
Service Facility.
10
.