Problem
Icemaker is not
Refrigerator was recently installed
making ice.
or icemaker recently connected.
Icemaker not turned on.
The ice detecting sensor is
obstructed.
The refrigerator is not connected to
a water supply or the supply shutoff
valve is not turned on.
Icemaker shutoff (arm or sensor)
obstructed.
Reverse osmosis water filtration
system is connected to your cold
water supply.
40
Possible Causes
Care and Maintenance
Solutions
It may take up to 24 hours for each
compartment to reach the desired
temperature and for the icemaker to begin
making ice.
Locate the icemaker on/off switch and
confirm that it is in the ON (I) position.
Foreign substances or frost on the ice-
detecting sensor can interrupt ice
production. Make sure that the sensor area
is clean at all times for proper operation.
Connect refrigerator to the water supply and
turn the water shutoff valve fully open.
If your icemaker is equipped with an ice
shutoff arm, make sure that the arm moves
freely. If your icemaker is equipped with the
electronic ice shutoff sensor, make sure that
there is a clear path between the two
sensors.
Reverse osmosis filtration systems can
reduce the water pressure below the
minimum amount and result in icemaker
issues. (Refer to the Water Pressure
section.)