Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
• Save all instructions
A
Maintenance Schedule
WARNING
Before performing any maintenance, turn engine off and remove the wire from the spark plug to prevent accidental
starting and serious injury.
IMPORTANT: The warranty on this edger does not cover items that have been subjected to operator abuse or negligence.
To receive full value from the warranty, the operator must maintain the edger as instructed in this manual, and only use
genuine replacement parts. The following table lists required periodic maintenance.
PERIODIC MAINTENANCE SCHEDULE TABLE
Service Records-
Fill in dates as you complete regular
service
Check Engine Oil Level,
Fill to Proper Level
Check Connection of BOTH
Flameout Wire Connectors
Clean Debris From Unit
Lubricate All Pivot Points
Check Fasteners for Tightness
Check Drive Belt
Replace if Necessary
Check Blade for Wear or Damage
Replace if Necessary
Check Fuel Line
Replace if Necessary
Lubricate Wheel Axles
Check Spark Plug
Replace if Necessary
Change Engine Oil
Clean Air Filter
Replace if Necessary
Replace Spark Plug
Clean Combustion Deposits from
Cylinder, Piston, and Valves
CAUTION
IMPORTANT NOTES about Maintenance schedule
1. Re-check tightness of all fasteners after first 2 hours of initial use
2. Change engine oil after first 5-8 hours of initial use
3. Change oil every 25 hours if operating under heavy load or in high temperatures
4. Clean air filter every 10 hours if operating under dusty conditions.
WARNING
Use only GENUINE replacement parts. Other parts may damage the unit or result in injury.
Questions? Call Toll Free at 1-800-737-2112
After
After
Every
Before
Every
25 Hours
Each Use
10 Hours
of Use
of Use
√
√
√
√
√
√
√
11
After
After Every
Every
50 Hours of
100 Hour
Use
of Use
√
√
√
√
√
√
√
Copyright © 2008 MAT Engine Technologies, LLC
Before
See
Before
Each
Note
Storage
Season
Below
√
√
√
√
√
√
√
1
√
√
√
√
√
√
√
√
2,3
√
4
Publicidad
