Publicidad
Idiomas disponibles
Idiomas disponibles
• Determine the appropriate installation location for the
thermostat
The thermostat should face the bed area of the
room.
The thermostat must not be installed near or on
metal structures or surfaces including metal air
ducting that may be in the wall.
reduce the range of the wireless signal.
A. Refer to the Zoneline Owner's Manual to change
the AUX setting to 6A (class 2 mode). The unit will
display "use wall thermostat" when finished.
B. Zoneline output is 24VAC. Be sure the jumper on the
wireless control card is on the AC position – jumper
is connecting "R" and "C" (common) pins. This is the
default position.
Other Zoneline Auxilary Control Settings for use with
*DBM & *EBM Models
• Mode E: Enables Zoneline Makeup air vent door control
turned on to utilize this feature.
• Refer to the Zonelines Owner's Manual for instructions
on how to change this AUX setting/mode.
49-5000416 Rev. 1
Before You Begin
5
Publicidad
