Fenton RP161 Manual De Instrucciones página 3

OVERVIEW
1. Lift Lever
Raises and lowers the tonearm.
2. Tone Arm
3. 33 / 45 / 78 RPM Switch
This switch controls the RPM of the turntable platter.
4. Autostop Switch ON/OFF
This switch turns auto stop on or off. When the automatic stop is
enabled, the platform will start rotating as soon as the tone arm is
placed over the record and will stop rotating when it has reached the
end of the record. Some vinyl records stop before the end or do not
stop when the end is reached. In this case set Auto-stop to OFF.
5. Arm Locking Clip
This specially designed arm clip secures the tonearm while at rest or
when not in use. The arm clip has been designed to remain in the up
position while unlocked.
6. Cartridge with Needle
When the turntable is not in use, it is recommendable to place the
removable protection cover on the stylus.
7. Power & Volume Control Knob
To power on the record player, turn this knob clockwise until it clicks.
When powered on, use this knob to adjust the volume. To turn off the
record player, turn this knob counter clockwise until it clicks.
8. 45RPM Adapter
This adapter allows you to play 45RPM records.
9. Platter
Place your record here.
10. Spindle
11. RCA Line Output
The audio from a playing vinyl record is sent to this line-level coaxial audio output. This must not be connected to phono
level devices.
12. DC IN Port
Connecting the 5Volt/DC power adapter.
13. Dust Cover
BT CONNECTION
1. Turn on the device. The default mode is BT streaming mode (when the auto-stop ON/OFF switch is at ON position). The
indicator will flash in blue color.
2. Turn on the BT function on your mobile device and search for "Fenton recordplayer". After successful pairing, the indicator
will stop flashing. You can now play your music of your mobile phone or tablet PC on this turntable player.
Turn the VOLUME CONTROL KNOB to adjust the volume (the mobile device's volume control also impacts the overall
volume level).
OPERATION
1. Connect the record player with the power adapter and plug the other end into a wall power outlet.
2. Remove the white protective needle cover by gently pulling towards the front of the unit.
3. Turn the power & volume control knob clockwise to turn on the record player.
4. Place a vinyl record on the turntable platter and select the desired speed (33/45/78RPM) according to
the record. NOTE: when playing a 45RPM record, use the included 45RPM adapter.
5. Open the tone arm clip to release the tone arm. Push the lift lever(it sits beside the auto stop switch)
backwards to raise the tone arm and gently move the tone arm to the desired position over the record.
The turntable will begin to spin when the tonearm is moved toward the record(when the AUTO STOP
switch is ON). Push the lift lever forwards to lower the tone arm slowly onto the desired position on the record to start
playback.
6. Turn the volume control knob to adjust the volume.
NOTE: If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when finished. If Auto Stop Control is
turned OFF, record will NOT stop automatically when finished. The AUTO STOP function applies to most 33RPM vinyl records.
However, for some records, it will stop when it does not come to the end, or it will not stop when it comes to the end when
AUTO STOP is ON.
RCA OUTPUT MODE
Connect your own speaker system to the RCA port of the record player with an RCA-3.5mm audio cable (not included).
NOTE: the RCA cables are color coded. The red plug cable must be plugged into the red jack on both the record player and
external amplifier or speaker system. The white plug cable must be plugged into the white jack on both the record player and
external amplifier or speaker system.
3