Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Lay Table Top Assembly painted side down, on a smooth,
flat surface. Use the shipping carton to protect the painted
surface of the table top. Attach legs (#19 & 24) to table
top with Hex Bolt (#29), two Plastic Washers (#38) and
Locknut (#34). Attach leg brace to Leg Mounting Bracket
(#25) with Phillips Head Screw (#23) and #10-24 Locknut
(#44) as shown in Detail 1. Attach leg caps (#26) to
bottom of the legs (#19 & 24) as shown in Figure 3.
5. Rotate U-support (#21) that is on bottom of Table Top
Assembly until you see the screw holes in the slots of U-
clips (#22). Slide U-support (#21) side to side if
necessary to see holes. See Figure 3.
6. Insert Screw (#35) through slot in U-clip (#22) and into
U-support (#21). See Figure 3. Thread screw all the way
into U-support until it touches the back of the tube. There
should be about 3/8" of screw (#35) left sticking out.
Repeat for other screw as shown in Figure 3.
7. Repeat steps 4 through 6 on other table top assembly.
26
19- Left Hand
Leg Assembly
Figure 3
Note: Slide U-Support back and forth
until you see the hole if necessary.
29
20
35
21
35
22
21
4
19
Detail 1
38
34
44
35
Leg Brace
23
25
24- Right Hand
Leg Assembly
Table Top
Assembly
Publicidad
