Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
• Do not step onto the platform before the platform beeps once and the Green Indicator Light blinks.
• Do not step off until hearing a double beep or the Green Light remains solid (stops blinking), the measurement is taken, and the
readings are displayed on the applicable device (e.g. Garmin Watch, TANITA Remote Display, and/or PC).
• If you do not step onto the platform within 30 seconds after Green Indicator Light begins blinking, the power will shut-off automati-
cally.
• Interference may occur if multiple platforms are present. Please use only one platform in any given area.
• Constant Red Indicator Light
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned on the measuring platform.
Make sure to step onto the platform only after it has beeped once or the Green Indicator Light is blinking.
The unit cannot accurately measure your weight if it detects movement. Please stand on the platform keeping movement to a
minimum.
If Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.
Reading cannot be obtained if the weight capacity is exceeded. Weight capacity is 330lb (150kg).
• Blinking Red Indicator Light
Batteries are low. When the Red Indicator Light is blinking, replace the batteries immediately, since weak batteries will affect the
accuracy of your measurements. Change all the batteries at the same time with new batteries.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
Specifications
BC-1500 PRO
Weight Capacity
330lb (150kg)
Weight Increments
0.2lb/0.1kg
Time accuracy
Within ±1 minute per month (normal temperature)*
Power Supply
DC 6V (AA Battery-LR6 × 4 included)
Power Consumption
100mA Maximum
* normal temperature
23°C ± 5°C(64.4°F - 82.4°F)
Humidity 50% ± 20%
All manuals and user guides at all-guides.com
Federal Communications Commission and Canadian ICES Notice
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio or television technician for help.
en
13
Publicidad
