Atlas Copco TEX 21PE Instrucciones De Seguridad Y De Funcionamiento página 9

TEX 20PS, 21PE, 32P/PS, 33PE, 39P/PS, 40PE, P60/S,
P90/S
WARNING Ejected oil plug
If the oil plug on a pressurized machine comes loose
it can blow out and cause personal injury.
Before loosening the oil plug, the compressed air
►
must be switched off by the compressor and the
system must be bled.
Before starting the machine, check that the threads
►
on the oil plug and in the lubricator are not
damaged or worn out.
► Check that the O-ring on the oil plug is in place
and that it is not damaged or worn out.
WARNING Ejected insertion tool
If the tool retainer on the machine is not in a locked
position, the inserted tool can be ejected with force,
which can cause personal injury.
Never start the machine while changing the
►
insertion tool.
► Before changing the insertion tool or accessories,
stop the machine, switch off the power supply and
bleed the machine by activating the start and stop
device.
► Never point the inserted tool at yourself or anyone
else.
Make sure that the insertion tool is fully inserted
►
and the tool retainer is in a locked position before
the machine is started.
Check the locking function by pulling the inserted
►
tool outwards forcefully.
WARNING Moving or slipping insertion tool
An incorrect dimension of the inserted tool's shank
can result in that the inserted tool is lost or is slipping
out during operation. Risk of severe injury or crushed
hands and fingers.
► Check that the insertion tool has the shank length
and dimensions that the machine is intended for.
Never use an insertion tool without a collar.
►
© 2014 Construction Tools PC AB | No. 9800 0650 90c | 2014-07-03
Original instructions
Safety and operating instructions
Operation, precautions
DANGER Explosion hazard
If an working tool comes into contact with explosives
or explosive gases, an explosion could occur. When
working on certain materials and when using certain
materials in machine parts, sparks and ignition can
occur. Explosions will lead to severe injuries or death.
Never operate the machine in any explosive
►
environment.
► Never use the machine near flammable materials,
fumes or dust.
Make sure that there are no undetected sources
►
of gas or explosives.
WARNING Unexpected movements
The inserted tool is exposed to heavy strains when
the machine is used. The inserted tool may break
due to fatigue after a certain amount of use. If the
inserted tool breaks or gets stuck, there may be
sudden and unexpected movement that can cause
injuries. Furthermore, losing your balance or slipping
may cause injury.
Make sure that you always keep a stable position
►
with your feet as far apart as your shoulder width,
and keeping a balanced body weight.
► Always inspect the equipment prior to use. Never
use the equipment if you suspect that it is
damaged.
Make sure that the handles are clean and free of
►
grease and oil.
Keep your feet away from the inserted tool.
►
► Stand firmly and always hold on to the machine
with both hands.
Never start the machine when it is lying on the
►
ground.
Never 'ride' on the machine with one leg over the
►
handle.
► Never strike or abuse the equipment.
Check regularly for wear on the insertion tool, and
►
check whether there are any signs of damage or
visible cracks.
Pay attention and look at what you are doing.
►
9