Teuco KO40 Instrucciones De Montaje página 7

For the purposes of guarantee validity, the product must be installed as supplied by Teuco.
GB
It is necessary to follow the assembly instructions and only to use the recommended materials and
equipment and the accessories supplied with the product.
This manual is an integral part of the product and therefore, it must be kept in a safe place for future
use, if necessary.
The data and characteristics indicated are in no way binding for Teuco Guzzini Spa, which reserves
the right to make any changes it deems fit without any obligation to give prior warning or supply
replacements.
This product has been devised for residential use only. In the event of public use, it is necessary to
guarantee full compliance with specific legislation and standards as well as with the technical and
safety requirements foreseen by Teuco.
The fitter/owner is responsible for checking and adhering to specific local instructions prior to
installation.
All of the fastenings supplied with the product must only be used for the purposes of mounting on
cement mortar walls.
All measurements on the figures in this manual are given in millimetres (mm)
1
PARTS SUPPLIED:
The following section describes the parts supplied for
fitting the Shelf:
•
Shelf
•
2 plugs
•
2Phillips screws
2
INSTALLATION:
The following section illustrates the installation process
for the Shelf:
•
BORING THE WALL
Bore 2 holes into the wall, as illustrated in Figure 2.
Insert the two plugs supplied into the wall, one in each
hole, so as to allow the shelf to be fixed into place.
•
FIXING THE SHELF BODY
Position the body of the shelf so that its holes are level
with the ones previously bored in the wall and fix it into
place using the two screws supplied (as illustrated in
Figure 3).
•
FIXING THE FRONT PART OF THE SHELF
Bring the front part of the shelf up against the shelf
body previously secured to the wall.
Tighten the two parts using the 2 screws, as illustrated
in Figure 4.
7