Volpi Kamikaze KV380 Manual Del Usuario página 37

14.2. Opening change
The KV380 pruner is equipped with a blade opening change system with memory.
It means that it is possible to adjust the opening of the blade according to the desired cutting
diameter.
The opening of the blades can be adjusted in three positions:
- 100% blades opening
- Approx 85% blades opening
- Approx 70% blades opening
Procedure to adjust the opening of the blade:
• Press the power button. After the sound signal, press the trigger twice in rapid sequence to
open the blades - 100% blades opening.
• Press the power button - approx 85% blades opening.
• Press the power button - approx 70% blades opening.
• Press the power button - 100% blades opening.
15. Maintenance and cleaning
Tools to be repaired must be sent to Customer Assistance Service. Use original part keeps the
tool good condition and safe.
Disconnect the battery from the tool before checking, maintaining and repairing the pruning
shear, to avoid risk of unexpected activation of the tool.
Warning!
In particular situations of very hard use, the blade and the handle could reach high temperatures. It is
recommended to handle the pruner with care, using protective gloves.
Please wear glove before you check the blade is sharp or not, that is to avoid blade hurt you.
Check the pruning shear frequently, this will keep tool safe and reliable.
•
Do not flush the tools or put it in water, it will cause short circuit or damage the device.
•
Keep ventilation, motor and handle cleaning, always use feather clean the device. Do not use
cleanser flush device, it will rust parts.
•
Clean the blade after every use, protect by oil or spray protection.
•
After continuous work for 8 hours, please open the trigger cover protection of the equipment and
clean up wood chips and other impurities
37