Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
B
A
A
B
D
• Use threads sealing tape in all the connections (A).
• If the piping is D 3/4", connect the pump directly into the
inlet and outlet pipes.
If the piping is D 1/2", use the reduction nuts (included) to
screw them into the pipes inlet and outlet (B).
• Keep the closing valves (C) open a few seconds to clean
and remove any particle from the inlet and outlet
connections before installing the pump.
• Setting a filter in the inlet pipe (D) is recommended .
• Fix the pump (E).
• Set the selector key OFF and open the inlet and outlet
C
valves (F).
• Connect the pump to a grounded power inlet (G).
• Set the selector key in automatic mode (H).
G
E
F
F
OFF
Automatic
ENGLISH
H
7
Publicidad
