Manuales relacionados para Truper PRES-1
Resumen de contenidos para Truper PRES-1
- Página 1 Manual Water pressure 1 HP booster pump Power Applies for: Code Model 19397 PRES-1 PRES-1 Read this manual thoroughly CAUTION before using the tool.
-
Página 2: Tabla De Contenido
Manual before Parts using the tool. Assembly Keep this manual for future references. Start up The illustrations in this manual are for reference Maintenance only. They might be different from the real tool. Troubleshooting Notes Authorized Service Centers Warranty PRES-1 ENGLISH... -
Página 3: Technical Data
Technical data PRES-1 Code 19397 Description Water pressure booster pump Voltage 127 V Frequency 60 Hz Current 6.6 A Power 1 Hp Speed 3450 RPM Input and output diameter 1 NPT Maximum depth Maximum height / Maximum Value 26.2 ft 124.6 ft... -
Página 4: General Power Tools Safety Warnings
General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Página 5: Safety Warnings For Water Pumps
Safety warnings for water pumps Adequate Use CAUTION • Do not subject the device to rain. Do • The stationary and semi-stationary device is designed to pump clean water at home or garden. To spray or water not use the device around wet areas. WARNING •... -
Página 6: Parts
Parts Pressurized water outlet Control automatic switch Power cord Starting switch Carrying Coupling handle Purge Water intake Pump Engine Water drain cap Assembly Automatic switch coupling Installation • Fix the automatic switch control with the coupling nut • The device shall be set in a horizontal surface that can and tighten by hand. -
Página 7: Start Up
Assembly Connecting the lines • The suction line shall be set up preventing any mechanical forces or tension onto the pump. • Both lines shall be perfectly sealed. Leaks cause air to escape and stop or reduce the water outlet. Prevent elbows or slopes to prevent air building inside the pipe thus, affecting the pressurizer efficiency. -
Página 8: Maintenance
Start up Automatic switch • The switch will automatically start the pump when water Encendido is needed (if the pressure line is open water pressure gets reduced below the starting pressure). Presurizador encendido • The switch automatically turns off the pump when the pressure line is closed (when the pressure of the water Falla increases above the shutdown pressure). -
Página 9: Troubleshooting
Troubleshooting Problem Cause Solution The pump is not • No power. • Double-check the cable and fuse. working. • Overheating. Water temperature is too high. • Prevent the cause of overheating. Wait for the water to cool down. • Overheating. Obstructed ventilation slots. •... -
Página 10: Notes
Notes ENGLISH... -
Página 11: Authorized Service Centers
Authorized Service Centers In the event of any problem contacting a Service Center, please see our webpage www.truper.com to get an updated list, or call our toll-free numbers (800) 690-6990 or (800) 018-7873 to get information about the nearest Authorized Service Center. -
Página 12: Warranty
. Transportation costs resulting from compliance of this warranty will be covered by For questions or comments, call 800-690-6990. Made in China. Imported by Truper S.A. de C.V. Parque Industrial 1, Parque Industrial Jilotepec, Jilotepec, Edo. de Méx. C.P. 54257 Stamp of the business.