Axis Communications T93G Serie Manual De Instrucciones página 10

AXIS T93G Series
Important
Make sure the camera is attached in the correct direction on the holder, see the illustration
below.
4. Attach the camera to the holder. Align the pin and camera screw with the pin hole and
screw mount on the camera and tighten the camera screw (torque 1 Nm). Be careful not
to overtighten the screw.
1
Holder
2
Holder screw T20 (2x)
3 Pin
4
Camera screw T20
5. Adjust the position of the holder carefully and then tighten the holder screws (torque
0.5 Nm).
NO NO NO TICE TICE TICE
To fulfill the IK10 rating requirements, adjust the holder's position so that the camera lens
(4) is aligned with the housing edge (3), see the illustration.
www.a1securitycameras.com email: sales@a1securitycameras.com
Available from A1 Security Cameras
10
1
3
4