Publicidad
Idiomas disponibles
Idiomas disponibles
5. Installation
5.1 Guidelines
The construction to which the device is attached should be able to
support 4 times the weight of the device for one hour without
deformation.
Never stand directly below the device when it is being mounted,
removed or serviced. Have a qualified technician check the device once
a year and once before you bring it into service.
Overhead mounting requires extensive experience: calculating workload
limits, determining the installation material to be used... Have the
material and the device itself checked regularly. Do not attempt to
install the device yourself if you lack these qualifications as improper
installation may result in serious injuries.
This device is not suitable for dimming.
5.2 Distances
Keep at least 20 cm distance at the top and 30 cm on either side.
Respect a minimum distance of 1 m between the device's light output
and any illuminated surface.
5.3 Choosing an appropriate location
You can adjust the detection area according to your needs: turn the
device to the left or right and aim it up or down. Note that the detector
is much more sensitive to objects moving across the detection area
than it is to objects coming straight at it. This is a very important
consideration when selecting the mounting location.
Please avoid installing the floodlight upside-down in order to ensure its
watertightness.
The floodlight should be fixed to a stable outdoor wall made of a non-
flammable material approximately 2.3-3.0 m above the ground and at
an angle of max. 30°, preferably in a location under eaves where the
unit is protected from the elements and shielded from direct sunlight.
Do not block the front of the detection window and make sure the
detection area holds no moving objects.
Do not install the device close to air conditioning vents, radiators, etc.
V. 02 – 16/11/2015
LEDA200xNW-BP
5
©Velleman nv
Publicidad
