Makita RF1100 Manual De Instrucciones página 6

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing the bit
CAUTION:
Do not tighten the collet chuck without inserting a
•
bit, or the collet chuck will break.
When using bit of bigger than 1-1/4" in diameter,
•
install base plate with center hole diameter 2-1/2",
replacing the original base plate.
First, remove the motor unit from the base as follows.
1. Open the lock lever.
003672
2. While holding the base, turn the motor unit
counterclockwise.
3. Turn it until the pin in the base is disengaged
from the groove in the motor unit. Lift the motor
unit free from the base.
Insert the bit all the way into the collet cone and tighten
the collet nut securely with the two wrenches.
003673
These routers accommodate the bits with 1/2" diameter
shank. When using the 1/4" diameter shank bit, replace
the equipped collet chuck with the one for 1/4" diameter
shank bit which is provided as the standard accessory.
To remove the bit, follow the installation procedure in
reverse.
Reinstall the motor unit
Install the motor unit into the base as follows.
1. Open the lock lever.
2. While holding the base, insert the motor unit into
the base aligning the pin with the groove in the
base.
1. Lock lever
1
1. Wrench
1
2. Router bit
2
003674
3. Confirm that the pin and the groove are aligning.
Rotate the motor unit clockwise into the base.
4. Close the lock lever.
For equipped with switch-in-handle
For model RD1101 only
003675
Connect the motor unit cord to the outlet in the handle.
OPERATION
Set the tool base on the workpiece to be cut without the
bit making any contact. Then turn the tool on and wait
until the bit attains full speed. Move the tool forward
over the workpiece surface, keeping the tool base flush
and advancing smoothly until the cutting is complete.
When doing edge cutting, the workpiece surface should
be on the left side of the bit in the feed direction.
1
2
3
1. Workpiece
2. Bit revolving direction
3. View from the top of the tool
4. Feed direction
001984
NOTE:
Moving the tool forward too fast may cause a poor
•
quality of cut, or damage to the bit or motor.
Moving the tool forward too slowly may burn and
mar the cut. The proper feed rate will depend on
the bit size, the kind of workpiece and depth of cut.
6
1. Pin
1
1. Motor unit cord
1
2. Outlet
2
2
4
4