Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING THE DEBRIS FILTER
We recommend cleaning the debris filter when water does not drain well or the "ND" error message is
displayed.
1. Open the filter cover by using a key or coin.
2. Unscrew the drain cap by turning it counter-
clockwise.
3. Hold the cap on the end of the drain tube and
slowly pull it out about 6inches (15cm) and
drain off all the water.
4. Remove the debris filter cap.
5. Wash any dirt or other material from the
debris filter. Make sure the drain pump
propeller behind the debris filter is not
blocked.
6. Replace the debris filter cap.
7. Replace the filter cover
8. Close up the opening of drain tube with cap.
9. Don't insert the drain tube in the hole
WF218ANB-02440B-04_EN.indd 17
Step 1
Step 2
maintaining your washer _17
2009-03-06 ¿ÀÈÄ 4:14:01
Publicidad
