Publicidad
Idiomas disponibles
Idiomas disponibles
Before you start
1. Bracket
2. Bolt M5×25
3. Convex of fitting plate
1. Blade retainer fixing slot
2. Blade retainer
3. Blade
1. Blade
All manuals and user guides at all-guides.com
4. Fitting plate
5. Notch of fitting plate
4. Lower blade retainer
5. Cup
6. Nut
2. Locking tool
18
Installation of bracket
Fit bracket to mounting portion of angle transmission and fix the
bracket by holding fitting plate pressed from beneath and tighten
4 bolts (M5×25) lightly.
Get notches and convexes of fitting plate to face corresponding
convexes and concaves of bracket, and fix bracket tightening 4
bolts (M5×25) securely.
There are two types of shields: namely one used exclusively for
nylon line cutting head and another one used exclusively for met-
al blade. When metal blade is used, use the shield for metal
blade.
Installing blade
Inspect blades before installation. Check for sharpness.
Dull blades increase the risk of blade kickback reactions.
Small cracks can develop into fractures resulting in a piece of
blade flying off during operation.
Discard cracked blades no matter how small the crack.
Blade retainer, blade, lower blade retainer, cup and nut finger
tight.
DANGER
If worn nut and cup for blade are used, there is a danger of
blade getting loose. Replace them with new one.
WARNING
Do not attempt to fit the trimmer blade with one hand or
without using the socket spanner. Fit the trimmer blade
accurately using the supplied socket spanner and tight-
en firmly in position.
The trimmer must not be used if the blade vibrates or is
loose.
Wear heavy duty gloves when working with the trimmer
blade. When replacing the trimmer blade during a trim-
ming task, ensure that the engine is switched off and
that the blades have stopped.
When turning the product over to replace the trimmer
blade, ensure that the fuel tank cap is securely in place.
Failure to do so could lead to an injury or serious accident,
or cause a fire.
Insert locking tool into a hole located on the right side of angle
transmission while forcing retainer spring to the left side. Insert
locking tool further into blade retainer fixing slot to fix output shaft.
CAUTION
Fasten output shaft using locking tool securely in order to
avoid the possibility of output shaft rotating when mount-
ing cutting blade which will prevent the cutting blade fas-
tening nut from being tightened sufficiently.
Publicidad
