Krüger & Matz KM0242 Manual Del Usuario página 34

Base stand assembly instruction
When you install the base, the need to face down flat on the TV platform. Before installing
(or removing) the stand, unplug the AC power cord from the AC outlet before performing
the operation, laying cushion in place the TV will be placed to prevent damage to the TV.
Warning:
Be sure to follow the instructions for installation, if the base is not installed correctly, it
may result in the TV falling over. To remove the stand, perform the steps in reverse order,
the base can not adjust the angle. During the installation process, being careful to avoid
damage to the TV and your hand caught and ground to the bottom of the TV.
34
Step 1
1. Flat base, the base will be one of
the pillars placed in the end seat,
make sure the screw holes on the
base and the base of the pillars
aligned.
2. Let screws into the base of the
hole and tighten the screw.
3. In the same way to install an-
other base pillars.
Note: Please use standard screws
packaging operation.
Step 2
1. Install the screw holes on the
back of the base and the base pil-
lars aligned television reserved.
Step 3
1. Let the four screws into the
screw holes and tighten the back
of the TV.
Note: Please use standard screws
packaging operation.
Owner's manual