Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS
1.
Freezer compartment
2.
Temperature control knob
3.
Glass shelf
4.
Vegetable drawer
5.
Levelling feet
6.
Door shelves
INSTALLATION
·
Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth.
·
Select a place with a strong, level floor.
·
Allow 10 cm of space between the back of the refrigerator and any adjacent wall.
·
Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
·
Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the
evaporator, and your refrigerator.
·
Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
·
After installation, leave the fridge for 24 hours before turning it on. This way the refrigerant can settle.
·
Allow the appliance to run empty for 8 hours so the compartment can cool to the appropriate
temperature.
·
For uneven surfaces, front feet can be aligned.
·
The climate class indicates the minimum and maximum ambient temperature for the proper operation
of an appliance. You can find the climate class on the type plate on the back of the appliance.
·
SN: Subnormal: ambient temperature between 10°C and 32°C
·
N: Normal: ambient temperature between 16°C and 32°C
·
ST: Subtropical: ambient temperature between 16°C and 38°C
·
T: Tropical: ambient temperature between 16°C and 43°C
32
DO91124
1
2
3
4
5
Lift
Lower
6
Publicidad
