Kenwood KDC-205 Manual De Instrucciones página 8

General features
Speaker Setting
Fine-tuning so that the System Q value is optimal when setting
the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STBY" display.
2
Enter Speaker Setting mode
Press the [Q] button.
3
Select the Speaker type
Press the [4] or [¢] button.
Each time the button is pressed the setting switches as shown
below.
Speaker type
OFF
For the OEM speaker
For 6 & 6x9 in. speaker
For 5 & 4 in. speaker
4
Exit Speaker Setting mode
Press the [Q] button.
Clock Display
Press the [CLK] button.
Each time the button is pressed the clock display turns ON or
OFF.
Display
"SP-F"
"SP-O"
"SP-6"
"SP-5"
— 8 —
Adjusting Clock
1
Select the clock display
Press the [CLK] button.
2
Enter clock adjustment mode
Press the [ADJ] button for at least 2 seconds.
The clock display blinks.
3
Adjust the hours
Press the [FM] or [AM] button.
Adjust the minutes
Press the [4] or [¢] button.
4
Exit clock adjustment mode
Press the [CLK] button.
DSI (Disabled System Indicator)
A red indicator will blink on the unit after the faceplate is
removed, warning potential thieves.
1
Turn the power OFF
Press the [SRC] button for at least 1 second.
2
Set the DSI
While pressing the [1] and [3] button, press the [SRC] button.
Each time the step 1 and 2 operation is done the DSI turns ON or
OFF.
Function of the KDC-205/KDC-205CR