Publicidad
1.8.2 Serial ATA Connectors
Each SATA connector serves as one single channel to connect one SATA device by SATA cable.
The RAID 0/1/0+1 configuration is also possible by the combination of disk arrays through
these SATA connectors:
For more information on how to configure the function mode for SATA, please refer to the item
"OnChip SATA Mode" in the BIOS setup menu of "OnChip IDE Device".
To connect SATA device:
1.
Attach either end of the signal cable
to the SATA connector on
motherboard. Attach the other end to
the SATA device.
2.
Attach the SATA power cable to the
SATA device and connect the other
end from the power supply.
The motherboard in this photo is served for DEMO only, and may not be the
※
same type or model as the one described in this user's manual.
1-12
Get user manuals:
See SafeManuals.com
F-I90HD
Publicidad
