GE AEC10 Manual De Instrucciones página 10

Installation Instructions
PREPARE THE AIR CONDITIONER
4
(cont.)
C
Remove the backing from the accordion seal
(two short strips). Stick one sealing strip
respectively on the left side and right side of the
accordion panels, as shown.
D
Slide the free end of the accordion panel into
the side panel rails. Slide the panel down. Be
sure to leave enough space to slip the top and
bottom of the frame into the rails on the cabinet.
NOTE: There is a right and a left accordion
panel. Be sure to use the proper panel for each
side.
Top mounting rail
E
Slide the left and right accordion panels into the
top and bottom mounting rails.
Top left
Bottom mounting rail
10
Bottom mounting rail
Top mounting rail
Top right
PREPARE THE WINDOW
5
Cut the window seal (2 long strips) to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash. One
attached to sash and one attached to sill.
INSTALL THE AIR CONDITIONER
6
IN THE WINDOW
Place the air conditioner on the sill with the
A
bottom mounting rail against its back edge.
Center it and close the window securely behind
the top mounting rail. It should be level or
1/3 bubble will be the correct case slant to the
outside.
3 Screws
(For AEC10 and AEC12 Models)
B
the vertical window sashes and attach 3 screws
through the holes in the upper panels, as
appropriate.
For AEC10 and AEC12 Models: Install the
C
frame locking brackets between the bottom of
the accordion panel and the window sill. Attach
with 2 screws.
NOTE: To prevent the
window sill from splitting,
drive the pilot holes before
driving the screws.
Sealing Strip
(with adhesive)
2 Frame locking brackets
49-7804-1