Publicidad
Idiomas disponibles
Idiomas disponibles
Installing Your New Appliance
Before using the appliance for the first
time, you should be informed of the
following tips.
Warning!
For proper installation, this refrigerator
must be placed on a level surface of hard
material that is the same height as the rest
of the flooring. This surface should be
strong enough to support a fully loaded
refrigerator.
The rollers, which are not castors, should
be only used for forward or backward
movement.
Moving
sideways may damage your floor and the
rollers.
Ventilation of appliance
In order to improve efficiency of
the cooling system and save
energy, it is necessary to maintain good
ventilation around the appliance for the
dissipation of heat. For this reason,
sufficient clear space should be available
around the refrigerator.
Suggestion:
It is advisable for there to be at least
75mm (3'') of clearance from the back of
the fridge to the wall, at least 100mm (4'')
of clearance from its top, at least 100mm
(4'') from its side to the wall and a clear
space in front to allow the doors to open
125° . As shown in following diagrams.
5
the
refrigerator
Note:
This appliance performs well within the
climate class from N to T shown in the
table below. It may not work properly if left
at a temperature above or below the
indicated range for a long period.
Climate class
Ambient temperature
SN
N
ST
+61℉ to +100℉
T
Stand your appliance in a dry place to
avoid high moisture.
Keep the appliance out of direct sunlight,
rain or frost. Stand the appliance away
from heat sources such as stoves, fires or
heaters.
Leveling of appliance
For sufficient leveling and air circulating
in the lower rear section of the appliance,
the bottom feet may need to be adjusted.
You can adjust them manually by hand or
by using a suitable tool.
To allow the doors to self-close, tilt the
top backwards by 10~15mm.
+50℉ to +90℉
+61℉ to +90℉
+61℉ to +109℉
Publicidad
