Velleman ED31168 Manual Del Usuario página 6

• The sensor can be used freestanding by unfolding the foldable stand or
hung on the wall by the suspension [S2]. Always placed the sensor in a
location protected from rain, moisture, splashing and dripping liquids.
7.
Operation
Alarm handling
• To enable the alarm, press the ALARM-button [E] shortly. The alarm-icon
appears. To disable it, press the ALARM-button [E] again.
• When the set time is reached, the alarm will sound. Format:
0~10s: 1 beep per second
11~20s: 2 beeps per second
21~30s: 4 beeps per second
31~120s: continuous beep.
• To go into snooze mode, press the SNOOZE-button [G]. The alarm is
postponed for ±5 minutes and the snooze-icon
• Pressing any other button will stop and exit the alarm.
Weather forecast [5]
•
The weather icon shows a forecast of the weather for the next 24h.
•
There are 4 icons:
sun sun/clouds
•
Place the weather station in a natural ventilated area (e.g. not in a room
with air-conditioning) to get more accurate results.
Temperature display [8 (indoor) / 10 (outdoor)]
•
The indoor temperature range [8] is 0~50°C (32~122°F), the outdoor
range [10] is -20°C~60°C (-4°F~140F).
•
To switch between °C and °F display on the weather station, press the
DOWN button [B] shortly.
Trend indicator [6 (indoor)/ 11 (outdoor)]
•
The trend indicator is based on the difference between a recorded
temperature and the current temperature. When the current temperature
is at least 1°C higher than the recorded, the arrow will point up and the
current temperature becomes the recorded. If the temperature is at least
1°C lower than the recorded value, the arrow will point down and the
current temperature becomes the recorded. In all other cases, the arrow
will be flat.
Note: the recorded temperature is set to the current temperature at
start-up or reset of the weather station.
07.10.2010
WS8707
raising
clouds
steady
6
appears (flashing).
rain
falling
©Velleman nv