Emptying The Dust Cup; Cleaning The Filters - Shark ROCKET IX140 Serie Manual Del Propietário

MAINTAINING YOUR VACUUM

EMPTYING THE DUST CUP

Press the wand release button to disconnect the
handheld vacuum from the wand.
REMOVING AND CLEANING THE DUST CUP
To remove the dust cup from the handheld vacuum,
press the Dust Cup Release button near the hand-
held vacuum nozzle. Tilt the dust cup and lift off to
remove.
To empty dust and debris, hold the dust cup over the
trash, then slide the Lid Release slider forward.
s h a r kc l e a n . c o m
1
To empty the Dust Cup while it is attached to the
handheld vacuum, position the dust cup over a trash
receptacle and slide the CleanTouch™ Lid Release
slider forward.
1
To clean the interior of the dust cup, rinse it with
water. Place it on its side to air-dry for at least 24
hours before reinstalling.
To clean filters, rinse them with water only. Allow all filters to air-dry completely for at least 24 hours before
2
reinstalling to prevent liquid from being drawn into electric parts. Clean the pre-motor filters at least once
a month and post-motor filter at least once a year. Tap off loose dirt between washes when needed. More
frequent cleaning may sometimes be necessary with heavy use. Cleaning the filters regularly helps maintain
your vacuum's cleaning performance.
IMPORTANT: DO NOT use soap when cleaning the filters. Use water only.
PRE-MOTOR FILTER
Press the dust cup release button and remove the
dust cup. Pull the foam and felt filters out of the
back of the dust cup.
2
Pre-Motor Foam and Felt Filter Kit
NOTE: Not all units come with a HEPA filter. See the enclosed Quick Start Guide for your unit's configuration. To order
additional accessories, visit sharkaccessories.com.
MAINTAINING YOUR VACUUM

CLEANING THE FILTERS

POST-MOTOR FILTER
Remove the dust cup. Pull the post-motor filter out
of the handheld vacuum.
Post-Motor HEPA Filter Post-Motor Filter
s h a r kc l e a n . c o m