Publicidad
8
TFM Series
11.
其他的重要信息
¼ '' TS
13.
14.
15.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
法律声明
12.
MUSIC Group
MIDAS, KLARK TEKNIK, LAB GRUPPEN,
LAKE, TANNOY, TURBOSOUND, TC ELECTRONIC,
TC HELICON, BEHRINGER, BUGERA
MUSIC Group IP Ltd.
© MUSIC Group IP Ltd. 2016
保修条款
music-group.com/warranty
16.
17.
2000
Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further information about this or any other product, please visit
our website at turbosound.com.
Unpacking the Loudspeaker
After unpacking the unit, please check carefully for damage. If damage is found, please notify your supplier at once. You, the consignee, must instigate any claim.
Please retain all packaging in case of future return shipment.
DDA
System Requirements
The TFM122M and TFM152M models are switchable passive / bi-amp 2-way loudspeakers.
Passive operation (full range or with a subwoofer) requires 1 amplifi er channel and 1 controller channel. The input signal is divided between the low-frequency and
high-frequency drivers internally with a passive crossover. Bi-amp operation (full range or with a subwoofer) requires 2 amplifi er channels and 2 controller channels,
one for low frequencies one for high frequencies. The input signal is divided between the low frequency and high frequency driver in the controller and the individual
amplifi ed signals are fed to the speaker input.
Correct controller settings for all models operation and subwoofers can be downloaded from turbosound.com, and are also available as presents for LAB GRUPPEN
amplifi ers, and for LAKE LM processors. To avoid wasting amplifi er power, you should use heavy-duty speaker cable with a minimum wire size of 1.5 mm2 (16 AWG),
and preferably 2.5 mm2 (14 AWG) for longer runs. For extreme cable lengths, be aware of cable impedance and resistive losses. Always observe the correct polarity.
Quick Start Guide
9
Publicidad
