Publicidad
Idiomas disponibles
Idiomas disponibles
2. Preset Store
You may store your preferred DAB stations to the preset station memories. There are 20
memory presets in your radio. Presets are remembered by your radio in the event of a power
failure.
The procedure for setting presets and using them to tune stations is the same for DAB modes:
In DAB mode, select the desired wave band. Press [▲, ▼] to view the stored stations, press
or
to tune to the required station as previously described, and then press [ENTER]
to select the desired preset number under which you will store the station. Press [ENTER] to
confirm.
FM Radio
Carefully extend the telescopic aerial to its full length.
Auto Scan
1. Press the SOURCE key to select "FM Mode".
2. Long Press
of sufficient signal strength.
3. After a few seconds, the display will update. The display will show the station frequency. If the
signal is strong enough and the station signal contains RDS data, then the radio will display
the station name.
4. To find other stations, press and hold the
5. To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
6. When the waveband end is reached, your radio will recommence tuning from the opposite
waveband end.
Manual Scan
1. Press the SOURCE key on the main unit to select "FM Mode''.
2. Select FM mode as previously described, if required.
3. Press
or
up or down by 50 kHz.
4. When the waveband end is reached, the radio will recommence tuning from the opposite
waveband end. If no stations are found, please ensure the aerial is extended and test the
reception by doing another auto scan in a different location.
Menu
1. Scan Setting
In FM mode, press MENU, enter the FM menu setting, then press
setting], then press ENTER to select the sensitivity setting:
1.1. All stations: ~15dB
1.2.
Strong stations only: ~19dB,
button, and your radio will scan and stop automatically when it finds a station
to tune to a station. Each press of the tuning button will change the frequency
button as before.
- EN 9 -
or
to select [Scan
Publicidad
