Descargar Imprimir esta página

Hitachi P50V701 Guia De Instalacion página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

All manuals and user guides at all-guides.com
Accessories
Check to make sure you have the following accessories before disposing of the packing material.
³
Remote Control
For U.S. models:
For optional accessories, please access our web site at: www.hitachi.us/tv
CAUTION:
³ Remote Control Unit CLU-4374A
(Part No. HL02404).
· Two "AA" size, 1.5V batteries.
» Power Swivel Table Top Stand
(Part No. QJ03754)
¿ Power Cord (P# EV01841).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pushing down and sliding the back cover off.
2. Insert two new "AA" size batteries for the remote control. When replacing old batteries, push them towards the
springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery
compartment.
4. Insert the bottom of the battery, the (-) side, into the battery
compartment first, push towards the springs and insert the
top of the battery, the (+) side, into place. Do not force the
battery into the battery compartment.
5. Replace the cover.
CAUTION: Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
4
·
Two "AA" size,
1.5V batteries
´ Power Swivel Cable
¿
Power Cord
1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
2.
This stand for use only with Hitachi P50V701.
capable of resulting in instability causing possible injury.
3.
The wall mount unit for the 50" model is WM07S. Please see page 7 for important
related to the wall mount. Wall Mount unit is an optional accessory (Not Included).
´ Power Swivel Cable (Part No. EW08433).
²
»
Power Swivel Table
Top Stand (included)
²
Wire clamp
Use with other apparatus is
Two IR Blaster cables (P# EY01641).
Wire clamp
Bottom View (Remote Control)
Lift up on tab to remove back cover.
Two IR Blaster Cables

Publicidad

loading