Jonsered CS 2238 EN Manual Del Usuario página 10

3. Put the guide bar above the bar bolts. Steer the
guide bar to its most rear position.
4. Put on protective chainsaw gloves.
5. Lift the saw chain above the drive sprocket and
engage it in the groove on the guide bar. Start on
the top edge of the guide bar.
10
A
6. Make sure that the edges of the cutting links are
turned forward on the top edge of the guide bar.
7. Assemble the sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
8. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket. Also make sure
that the saw chain is correctly engaged in the
groove in the guide bar.
9. Tighten the guide bar nuts with your fingers.
10. Tighten the saw chain by turning the chain
tensioning screw clockwise with the combination
wrench
. Tighten the saw chain until it does not sag from
below the guide bar, but you can turn it easily by
hand.
298 - 004 - 14.10.2019