KBS Brita 10-100A Manual Del Usuario página 13

4.2 Programming the Appliance
PROG
"BATT" flashes when the
battery has run out
4.2.1 Programming the Litre Information
Briefly press the "PROG" button
•
"PRG" flashes in the display
filter system manual.)
Note: Press the "PROG" button
changes.
Press the "RESET" button
•
flashes in the display
Press the "RESET" button
•
display
8
Press the "PROG" button
•
flashes.
Repeat the steps above until the litre information determined has been entered.
•
Press the "PROG" button
•
programming mode. The "PRG" field in the display
The litre information entered is shown in the display
EN
•
missioned.
4.3 Installation of the Sensor
Note: During installation, pay attention to the direction of flow.
Close the water inlet.
•
If a filter system is already installed, remove the outlet hose
•
nut.
Tighten the union nut
•
seal .
6
Tighten the outlet hose
•
Caution: The max. tightening torque at the 3/8" connections must not exceed
!
15 Nm!
4.4 Installation of the Display Unit
The display unit can be attached to the desired position with a velcro adhesive spot.
Caution: There must not be any water pipes or electrical
!
cables behind the mounting surface. Do not lay the connecting cable parallel to cables
conducting electricity because this can lead to an impairment of the sensor signal.
10
RESET
"PRG" flashes when the
9
.
8
9
.
7
7
of the sensor
5
on the sensor
4
PROG RESET
programming mode is
activated
, the display changes to the programming mode,
7
. (How to identify the filter capacity is described in the
8
again to leave programming without making any
7
to jump to the litre information. The relevant number
until the desired number is shown flashing in the
to reach the next digit to be entered. The relevant digit
to confirm the litre information entered and to leave the
on the filter head. If necessary, insert a flat
1
.
2
PROG
"1,2,3,4,5" flashes during
"Memory Call-Up" and
represents the memory
level that is being called up
no longer flashes.
8
, the system can now be com-
8
by loosening the union
4
RESET