Echo PAS-265ES Manual De Instrucciones página 17

1. Blade
1. Socket wrench
With nylon line cutting head
1. Bracket
2. Bolt
3. Button
2. Locking tool
2. Blade
4. Shield (for metal
blade)
5. Shield (for nylon line
cutting head)
Before you start
Insert locking tool into a hole located on the right side of angle
transmission while forcing retainer spring to the left side. Insert
locking tool further into blade retainer fixing slot to fix output shaft.
Fasten output shaft using locking tool securely in order to
avoid the possibility of output shaft rotating when mount-
ing cutting blade which will prevent the cutting blade fas-
tening nut from being tightened sufficiently.
Tighten the nut (turn anticlockwise) using a socket wrench.
Never fasten while applying your weight. Otherwise the thread of
nut could be broken.
Replace nut and cup with new ones no matter how small the wear
is.
Method to change shield
There are two types of shields: namely the one used exclusively
for nylon line cutting head and the other one used exclusively for
metal blade. When using nylon line cutting head, use the shield
for nylon line cutting head.
Fully loosen the bolt on the right side of the bracket to slide the
shield. The bolt itself cannot be removed from the bracket. Push-
ing the button, slide the shield to the left and remove it. Put shield
of other type into groove and slide it to the right until it stops. Be
sure to tighten the bolt.
15
CAUTION