Publicidad
Idiomas disponibles
Idiomas disponibles
Every day or every 10 hours
1. Check the engine oil level.
2. Check the radiator fluid level.
3. Check the fuel level.
4. Check Hydraulic oil level.
5. Check the tire pressure and lug nut torque.
6. Check the mast chains tension.
7. Clean the air filter outer cartridge.
8. Clean the radiator, oil cooler, and screens.
After the first 50 hours
1. Change the engine oil.
2. Change the engine oil filter.
3. Change the fuel filter cartridge.
4. Change the hydraulic pressure & return filters.
Every 50 hours service
1. Check the battery.
2. Grease fitting on the rear wheel pivot, steering cylinder, rotator pivot (if equipped), side shift bushings, side
shift cylinder and stabilizers.
3. Grease the rotating carriage sliding pads (if equipped).
4. Drain water / fuel separator.
5. Check fuel hoses and clamp bands.
Every 200 hours
1. Change the engine oil and oil filter.
2. Check the engine oil separator element and change if necessary.
3. Change the Outer air filter element & inspect the inner air filter, replace if dirty.
4. Check and adjust the alternator belt tension.
5. Inspect the hydraulic tank breather cap.
6. Check air intake line.
7. Check radiator hoses.
Every 400 hours
1. Change the fuel filter and water/fuel separator cartridges.
2. Change pressure & return Hydraulic filters
3. Check the forks for wear.
Bright Forklift
BD3–7570
SERVICING SCHEDULE
Never clean the inner filter.
(Or once a year if the forklift has not reached 400 hours of service)
Maintenance Instructions
IMPORTANT
33
Publicidad
