Sanyo DS27225 Manual Del Propietário página 4

BASIC SET-UP AND CONNECTIONS
INITIAL SET-UP
1. Install batteries in remote control,
see page 9.
2. Connect signal, see below.
3. Plug in AC power cord.
CONNECTING CABLE SERVICE, OR RF ANTENNA, OR SATELLITE DISH
RECEIVER TO TV
‚
Cable Box
OR
IN OUT
Notes:
– If you do not have a
cable box, connect
cable directly to TV 75
ohm jack or VCR.
– If you do not have a
VCR, connect signal
directly to TV 75 ohm
jack.
CATV FRANCHISE NOTE:
Cable companies, like public
utilities, are franchised by
local government authorities.
To receive cable programs,
even with equipment which is
capable of receiving cable
channels, the consumer
must subscribe to the cable
company's service.
I The TV will automatically select the correct Antenna mode
for the type of RF signal you connect.
I TV will switch off automatically after 15 minutes if there
is no signal reception (cable out or station not broad-
casting).
4
Need help?
Visit our Web site at
‚
Satellite Receiver
CATV IN
CH3
CH4
VIDEO L-AUDIO-R
IN FROM
OUT TO TV S-VIDEO
SAT.
VIDEO L-AUDIO-R
VCR Back
IN
FROM ANT.
OUT
OUT TO TV
AUDIO VIDEO
COMPONENT
2 INPUT 2
VIDEO
Y
P L (MONO)
B
P
R R
S-VIDEO
www.sanyoctv.com
4. Press POWER key to turn on TV.
5. Follow on-screen instructions, see
pages 10 ~ 12.
‚
RF Antenna
OR
Operational Tip for No Signal
Connection:
If the TV is used as a monitor only, with a
DVD player or some other type of external
equipment, and no cable or antenna signal
is available, the following setup is
necessary:
– Your TV is designed to automatically
TV Back
UHF/VHF/CATV
75Ω
– After the channel search process is com-
Exception—When the Video mode is selected, the TV will not
automatically switch off when signal reception has stopped
for 15 minutes.
I If you move the TV to a new location, press the RESET key
twice after connecting the signal and turning on the TV.
1-800-877-5032
or Call
search for available channels. Therefore,
the initial start up requires that you press
the MENU key, enabling the TV to auto-
matically go through the channel search
process before you can operate the TV.
After the initial channel search is com-
pleted, you must press the MENU key
again to complete the channel search
process. This may take several minutes.
plete (2 searches), you can press the
INPUT key on the remote control to use
the TV as a monitor.