GE AGH12 Manual Del Propietario E Instrucciones De Instalación página 12

Window Installation Instructions
INSTALL THE WINDOW LOCKING
6
BRACKET AND THE FOAM TOP
WINDOW GASKET
Attach a support bracket with a Type C
A
screw.
Cut the foam top window gasket to the
B
window width.
Stuff the foam between the glass and the
C
window to prevent air and insects from
getting into the room.
INSTALL THE AIR CONDITIONER
7
IN THE CASE
Slide the air conditioner into the case.
A
Reinstall the 2 screws removed earlier on
each side of the case.
Screw
Power cord
All manuals and user guides at all-guides.com
Screw
12
INSTALL THE AIR CONDITIONER
7
IN THE CASE (CONT.)
Before installing the front grille, pull out the
B
vent control lever located beside the unit
control panel, as shown.
Attach the front grille to the case by inserting
C
the tabs on the grille into the slots on the
front of the case. Push the grille in until it
snaps into place.
Guide the lever carefully
through the grille as you
push it in.
Lower the inlet grille and secure the front
D
frame with a type A screw through the
front grille. Raise the inlet grille back
into place.
Caulk or weather-strip any gaps or openings
to the outside to seal the installation.
Inlet grille