Publicidad
Idiomas disponibles
Idiomas disponibles
3
Attaching
Support
Bracket &
Bracket
Assembly
Model Series 820
through 849
NOTE:
If the grass collection
system is removed for
any reason, it is not
necessary to remove the
support brackets from the
tractor.
IMPORTANT:
There are two holes in
the clevis pin. Be sure
to insert the hairpin
clip in the upper hole
to properly secure the
bracket assembly to the
hitch plate.
Assembling Support
Brackets
Model Series 820 through 849
1. Locate the four self-tapping screws supplied in your
hardware pack (D from Figure 4). Attach one of
the grass catcher support brackets (F3 from Figure
4) using two of the supplied screws in position as
shown in Figure 13. Place the other grass catcher
support bracket (F3 from Figure 4) in position and
secure with the other two screws.
5. Insert a shoulder bolt (C in Figure 4) through a bell
washer, (B in Figure 4) and insert the bolt through
the remaining hole from the outside of the support
bracket. Secure with a nut (A in Figure 4). See Figure
13 for details. Repeat on other side.
NOTE: If the grass collection system is removed
for any reason, it is not necessary to remove the
support brackets from the tractor.
Attaching The Bracket
Assembly
1. Remove the two nuts and screws on each side of the
mounting bracket holding the hitch plate.
See Figure 14.
2. Rotate the hitch plate 180° from its original position.
Re-insert the four bolts through mounting bracket
and hitch plate frame and secure with nuts removed
earlier. Use the inner holes (closest to the mounting
hooks) on the mounting bracket. Refer to Figure 15.
3. Remove the hairpin clip and clevis pin from the hitch
plate as seen in Figure 14. Save the hardware.
4. Position the hooked ends of the mounting bracket
assembly to the outside of the support bracket and
over the shoulder bolts on both sides. Refer back to
Figure 11 for reference.
5. Reinsert the clevis pin through the aligned holes in
both the bracket assembly and the hitch plate and
secure with the hairpin clip removed earlier. See
Figure 16.
IMPORTANT: There are two holes in the clevis pin.
Be sure to insert the hairpin clip in the upper hole to
properly secure the bracket assembly to the hitch
plate.
Figure 13
Clevis Pin
Figure 14
Figure 15
Figure 16
8
Inner holes
Upper Hole
Publicidad
