Publicidad
Idiomas disponibles
Idiomas disponibles
Using Optical IN Mode
Connection
1. Follow the figure below to make the connections.
2. Turn the unit on. Press the STANDBY/SOURCE [7]
until the SOURCE LED indicator turns indigo.
Not all entertainment systems are setup
the same way; the diagram below is only
an example of a simple setup.
O P T IC A L I N
Optical Connection Cable
(not included)
Page 12
A U X I N
D C
5 . 8V, 2A
TV or DVD player etc.
OPTICAL OUT
Operate the external device as directed by its
manufacturer to control playback.
This optical connection only supports
the uncompressed PCM signal format.
You may need to adjust the digital
output format of your source device;
contact the device manufacturer to
learn more.
Using AUX IN Mode
AUX IN sources may include:
Rear
•
Personal audio players, mobile phones
View
•
Personal computers or laptops
AUX IN connection
1. Follow the figure below to make the connections.
2. Use a stereo 3.5mm to RCA jack cable (supplied)
to connect the RCA (Audio) output of the source
device (e.g., TV) to the AUX IN audio input jack
found on the back of the unit.
Naxa Electronics
Publicidad
