Porter Cable PC1800HD Manual De Instrucciones página 9

90550130 PC1800HD hammer drill
Installing and Removing the Battery Pack From the Tool
:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery
pack into tool as shown in figure C.
TO REMOVE BATTERY PACK: Depress the
battery release button as shown in figure D
and pull battery pack out of tool.
SAFETY WARNINGS AND INSTRUCTIONS: DRILLS
1. Hold drill firmly with one hand on the grip
and the other hand on the side handle as
shown in figure E.
2. When attaching accessories in the drill
chuck, hand tighten the keyless chuck
firmly.
:
Drill may stall (if overloaded
or improperly used) causing a twist. Always
expect the stall. Grip the drill firmly to
control the twisting action and prevent loss
of control which could cause personal injury.
If a stall does occur, release the trigger
immediately and determine the reason for
the stall before re-starting.
4/3/09 2:40 PM Page 9
C
D
E
9