Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE
18
TIME AND STATUS DISPLAY
The time and status display shows the estimated time remaining and cycle progress.
A
CYCLE STATUS INDICATOR
These LEDs will illuminate when a cycle
is selected to indicate which stages will
run. When a cycle is running, the LED for
the active stage will blink, and the LEDs
for the remaining stages will remain
steady. Once a stage is complete, the
LED will turn off. If a cycle is paused, the
active stage LED will stop blinking.
B
DELAY WASH INDICATOR
The Delay Wash Indicator will illuminate
when a delay wash is set. The indica-
tor light will turn off once the cycle has
started.
All manuals and user guides at all-guides.com
A
D
C
B
C
ESTIMATED TIME REMAINING
When a cycle is selected, the default
time for that cycle is displayed. This time
will change as modifiers or options are
selected. Once the START/PAUSE but-
ton is pressed, the washer will measure
the size of the load. The estimated time
may change once the load size has been
measured. If Delay Wash is set, the re-
maining delay time counts down until the
cycle begins.
NOTE: The time shown is only an esti-
mate. This time is based on normal oper-
ating conditions. Several external factors
(load size, room temperature, incoming
water temperature, etc.) can affect the
actual time.
D
LID LOCK INDICATOR
The Lid lock indicator will illuminate once
a cycle has started. The indicator light
will stay on until the cycle is paused,
stopped or has finished.
Publicidad
