Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Each end of the lower handle must be placed in the
same position on the mounting brackets.
a.
Remove the star knobs shown in Fig. 3-3 and remove
the lower handle.
Figure 3-3
b.
Position each handle bracket stud into the top hole
in the lower handle.
c.
Tighten the star knobs.
3.
Position the recoil starter by following the steps below:
a.
Hold the blade control against the upper handle.
b.
Slowly pull the starter rope out of the engine. See
Fig. 3-4.
C
Figure 3-4
c.
Slip the starter rope into the rope guide.
d.
Tighten the rope guide wing nut.
A
B
D
4.
Use the cable tie provided to secure cable to the lower
handle. Pull the cable tie tight and trim excess. See Fig. 3-5.
Figure 3-5
Rear Wheels
Install rear wheels as follows in Fig. 3-6 (wheels maybe already
installed at factory, if so disregard this step):
Figure 3-6
1.
Place rear of the mower deck on raised blocks.
2.
Remove lock nut from pivot arm assembly (on select
models, these may be included separately in a plastic bag).
3.
Slide wheel, with hollow side in, onto pivot arm and secure
with lock nut.
4.
Assemble the other side in the same manner.
s
ectiOn
3 — a
& s
-u
sseMbly
et
p
9
Publicidad
