Publicidad
Idiomas disponibles
Idiomas disponibles
Filling The Rinse Aid Reservoir
1
Remove the rinse reservoir cap by
lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is
designed to adjust the consumption by user. Follow the below steps.
1.
Open the door
Within 60 seconds after step 1, press the
2.
seconds,
aid indication
Press the
Program
3.
habits ,
the sets will change in the following sequence: D1->D2->D3->D4-
>D5->D1,
manufactory setting
4. Without operation in 5 seconds or press the power button to exit the set model,
the set success.
and Power on the dishwasher by plugging in;
and then press the Delay+ Button to enter the set model, the rinse
blinks as 1Hz frequency.
button to select the proper set according to your using
Dispenser drops more rinse aid in D5 level than in another, the
is D3.
2
Pour the rinse aid into the dispenser,
being careful not to overfill.
Program
12
button more than 5
Publicidad
